CUSTOMIZE PARAMETERS
HINT:
The following items can be customized.
NOTICE:
1. CUSTOMIZE
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menu: Body Electrical / Main Body or Illuminated Entry / Utility / Customize.
(e) Select the setting by referring to the table below.
Wireless Door Lock Control System
Display (item) |
Default |
Function |
Setting |
---|---|---|---|
Wireless Control |
ON |
Function that turns wireless door lock function ON/OFF |
ON or OFF |
Hazard Answer Back |
ON |
When the doors are locked by wireless operation, the hazard warning lights flash once. When the doors are unlocked by wireless operation, the hazard warning lights flash twice. |
ON or OFF |
Open Door Warning |
ON |
The buzzer sounds when LOCK is pressed when any of the doors are ajar. |
ON or OFF |
Unlock 2 Operation |
ON |
Function that unlocks driver side door when unlock switch on transmitter is pressed once, and unlocks all doors when pressed twice. If setting is OFF, pressing unlock switch once makes all doors unlock. |
ON or OFF |
Panic Function |
ON |
Function to operate theft deterrent system by continuously pressing panic switch on transmitter for 0.8 seconds |
ON or OFF |
Auto Lock Time |
60 s |
This function regulates the interval between unlocking and automatic relocking of doors. |
30 s, 60 s or 120 s |
Wireless Auto Lock |
ON |
This function turns the wireless auto lock function on or off. |
ON or OFF |
Wireless Buzzer Resp |
ON |
Wireless door lock buzzer response / ON or OFF |
ON or OFF |
Wireless Buzzer Vol |
Level7 |
Wireless door lock buzzer Volume |
Level7, Level6, Level5, Level4, Level3, Level2, Level1 or Level0 |
Installation
INSTALLATION
PROCEDURE
1. INSTALL STEREO COMPONENT TUNER ASSEMBLY
2. INSTALL NAVIGATION WIRE
(a) Connect the 3 connectors to install the navigation wire.
3. INSTALL STEREO COMPONENT TUNER ASSEMBLY WITH WIRE
(a) Install the stereo component tuner assembly ...
System Diagram
SYSTEM DIAGRAM
Transmitting ECU
(Transmitter)
Receiving ECU
Signal
Communication Method
Center Airbag Sensor Assembly
ECM
Crash detection signal
CAN
...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE TRANSFER AND TRANSAXLE SETTING STUD BOLT
(a) Remove the 4 transfer and transaxle setting stud bolts.
2. REMOVE NO. 2 TRANSFER CASE PLUG
(a) Remove the No. ...