Toyota Venza: Customize Parameters

Toyota Venza Service Manual / Door Lock / Wireless Door Lock Control System(w/ Smart Key System) / Customize Parameters

CUSTOMIZE PARAMETERS

1. CUSTOMIZING FUNCTION WITH THE TECHSTREAM

HINT:

The following items can be customized.

NOTICE:

When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.

2. CUSTOMIZE

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menu: Body Electrical / Main Body or Illuminated Entry / Utility / Customize.

(e) Select the setting by referring to the table below.

Wireless Door Lock Control System

Display (item)	Default	Function	Setting
Wireless Control	ON	Function that turns wireless door lock function ON/OFF	ON or OFF
Hazard Answer Back	ON	When the doors are locked by wireless operation, the hazard warning lights flash once. When the doors are unlocked by wireless operation, the hazard warning lights flash twice.	ON or OFF
Open Door Warning	ON	The buzzer sounds when LOCK is pressed when any of the doors are ajar.	ON or OFF
Unlock 2 Operation	ON	Function that unlocks driver side door when unlock switch on transmitter is pressed once, and unlocks all doors when pressed twice. If setting is OFF, pressing unlock switch once makes all doors unlock.	ON or OFF
Panic Function	ON	Function to operate theft deterrent system by continuously pressing panic switch on transmitter for 0.8 seconds	ON or OFF
Auto Lock Time	60 s	This function regulates the interval between unlocking and automatic relocking of doors.	30 s, 60 s or 120 s
Wireless Auto Lock	ON	This function turns the wireless auto lock function on or off.	ON or OFF
Wireless Buzzer Resp	ON	Wireless door lock buzzer response / ON or OFF	ON or OFF
Wireless Buzzer Vol	Level7	Wireless door lock buzzer Volume	Level7, Level6, Level5, Level4, Level3, Level2, Level1 or Level0

Operation Check

OPERATION CHECK 1. NOTICE WHEN CHECKING THE FOLLOWING (a) Power door lock/unlock function: This wireless door lock control function operates only when the following 3 conditions are met: (1) The ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials about Toyota Venza:

Power Management Control ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Power Management Control ECU Communication Stop Mode "Electric Power Control" is not displayed on the CAN Bus Check screen ...

Data Signal Circuit between Navigation Receiver Assembly and Extension Module
DESCRIPTION The stereo component tuner assembly sends the image data signal to the navigation receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK NAVIGATION WIRE (a) Remove the navigation wire (See pag ...

Fail-safe Chart
FAIL-SAFE CHART If a problem occurs in the power steering system, the power steering assist will be stopped or the amount of power assist will be decreased to protect the system. Power Steering System Malfunction Fail-safe Operation ...