CUSTOMIZE PARAMETERS
1. CUSTOMIZING FUNCTION WITH TECHSTREAM
HINT:
The following items can be customized.
NOTICE:
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Customize Setting / Door Lock or Illuminated Entry.
(e) Select the setting by referring to the table below.
Door Lock
Tester Display |
Default |
Content |
Setting |
---|---|---|---|
Unlock Key Twice |
ON |
Function that unlocks only the driver side door when the driver side door key cylinder is turned to unlock once, and unlock all doors when it is turned to unlock twice. For the OFF setting, turning it once unlocks all doors. |
ON or OFF |
Auto Lock |
OFF |
Function that locks all doors when the vehicle speed reaches a certain level. |
ON or OFF |
Auto Lock/Shift |
ON |
Function that locks all doors when the shift lever is moved from P to any position other than P when the engine is running and all doors are closed. |
ON or OFF |
Auto Unlock/Shift |
ON |
Function that unlocks all doors when the shift lever is moved to P from any position other than P while the ignition switch is ON. |
ON or OFF |
All Unlock/Open-Close |
OFF |
Function that unlocks the other doors when the driver side door is opened within 10 seconds after the ignition switch is turned to off. |
ON or OFF |
Display |
Default |
Content |
Setting |
---|---|---|---|
Lighting Time |
15 s |
Function that changes the lighting time after closing all doors. (It will quickly fade out in case of turning the ignition switch from off to ACC or ON.) |
7.5 s, 15 s or 30 s |
Speed Sensor Rotor Faulty (C1237/37,C1275/75-C1278/78)
DESCRIPTION
The skid control ECU measures the speed of each wheel by receiving signals from
the speed sensor.
These signals are used for recognizing that all four wheels are operating properly.
Therefore, all wheel signals must be equal.
DTCs C1275/75 to ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL AIR CONDITIONING UNIT ASSEMBLY
(a) Install the air conditioning unit assembly with the 3 nuts.
Torque:
9.8 N·m {100 kgf·cm, 87 in·lbf}
NOTICE:
Tighten the nuts in the order shown in the illustration to install the ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION
(a) Apply the parking brake.
(b) Turn the ignition switch to ON.
(c) Depress the brake pedal and check that the engine starts when the shift lever
is in N or P, b ...