DESCRIPTION
WIRING DIAGRAM
PROCEDURE
1. |
PERFORM ACTIVE TEST USING TECHSTREAM |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body / Combination Meter / Active Test.
(e) Check the CRUISE main indicator light by performing the Active Test.
Combination Meter
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
---|---|---|---|
Indicat. Lamp Cruise |
CRUISE main indicator light |
OFF or ON |
Confirm that the vehicle is stopped with the engine idling |
OK:
The CRUISE main indicator light blinks or goes off according to Techstream operation.
NG |
REPLACE COMBINATION METER ASSEMBLY |
|
2. |
READ VALUE USING TECHSTREAM |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Cruise Control / Data List.
(e) Check the Data List for proper functioning of the CRUISE main indicator light.
Cruise Control (ECM)
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
---|---|---|---|
CCS Indicator M-CPU |
CRUISE main indicator signal (Main CPU) / ON or OFF |
ON: CRUISE main indicator light on OFF: CRUISE main indicator light off |
- |
OK:
The display changes as shown above according to cruise control main switch operation.
Result |
Proceed to |
---|---|
OK |
A |
NG (for 1AR-FE) |
B |
NG (for 2GR-FE) |
C |
A |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
B |
REPLACE ECM |
C |
REPLACE ECM |
Removal
REMOVAL
PROCEDURE
1. REMOVE ROOF DRIP CENTER SIDE FINISH MOULDING (w/o Sliding Roof)
(a) Put protective tape around the roof drip center side finish moulding.
Text in Illustration
*1
Protective Tape
...
Steering Angle Sensor Circuit Malfunction (C1231/31)
DESCRIPTION
The steering angle sensor signal is sent to the skid control ECU via the CAN
communication system. When there is a malfunction in the CAN communication system,
it will be detected by the steering angle sensor zero point malfunction diagnostic ...
Purge Valve
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT NO. 1 VACUUM SWITCHING VALVE ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Te ...