MONITOR DESCRIPTION
The ECM continuously monitors its main and sub CPUs while cruise control is operating. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM illuminates the MIL and stores the DTC immediately.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
P1607 |
An ECM internal error (1 trip detection logic) |
ECM |
MONITOR STRATEGY
Related DTC |
P1607: Internal Control Module Performance |
Required sensors/Components (Main) |
ECM |
Required sensors/Components (Related) |
Cruise control |
Frequency of Operation |
Continuous |
Duration |
0.3 seconds |
MIL Operation |
Immediate |
Sequence of Operation |
None |
TYPICAL ENABLING CONDITIONS
Monitor runs whenever the following DTCs are not stored |
None |
Both of the following conditions are met |
- |
Cruise control |
Forbiddance |
DMA communication error |
Not detected |
TYPICAL MALFUNCTION THRESHOLDS
Either of the following conditions is met |
- |
Cruise control |
Operating |
Low speed control |
Operating |
CONFIRMATION DRIVING PATTERN
HINT:
Techstream Display |
Description |
---|---|
NORMAL |
|
ABNORMAL |
|
INCOMPLETE |
|
N/A |
|
HINT:
HINT:
CAUTION / NOTICE / HINT
HINT:
Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
PROCEDURE
1. |
READ OUTPUT DTC (DTC P1607) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Clear the DTC (See page ).
(e) Turn the ignition switch off and turn the Techstream off.
(f) Disconnect the Techstream.
(g) Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
(h) Connect the cable to the negative (-) battery terminal.
(i) Connect the Techstream to the DLC3.
(j) Turn the ignition switch to ON.
(k) Turn the Techstream on.
(l) Wait 16 seconds or more.
(m) Enter the following menus: Powertrain / Engine / Trouble Codes.
(n) Read the DTCs.
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC P1607 is output |
B |
A |
CHECK FOR INTERMITTENT PROBLEMS |
B |
REPLACE ECM |
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY
(a) Apply a light layer of lithium soap base glycol grease to the entire circumference
of 2 new brake master cylinder reservoir grommets.
(b) Install the 2 brake master cylinder res ...
Replacement
REPLACEMENT
PROCEDURE
1. REPLACE RING PIN
NOTICE:
It is not necessary to remove the ring pin unless it is being replaced.
(a) Remove the 12 ring pins.
(b) Using a plastic-faced hammer, install 12 new ring pins.
Standard Protrusion Height:
...
Floor mats
Use only floor mats designed specifically for vehicles of the same model and
model year as your vehicle. Fix them securely in place onto the carpet.
Insert the retaining hooks (clips) into the floor mat eyelets.
Turn the upper knob of each retaining ho ...