Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
3. REMOVE NO. 2 CONSOLE BOX CARPET
4. REMOVE CONSOLE BOX ASSEMBLY
5. REMOVE CONSOLE MOUNTING RETAINER ASSEMBLY
6. REMOVE CONSOLE BOX WIRE
7. REMOVE CONSOLE BOX ILLUMINATION LIGHT ASSEMBLY
(a) Disengage the 4 claws and remove the 2 console box illumination light assemblies. |
|
Inspection
INSPECTION
PROCEDURE
1. INSPECT CONSOLE BOX ILLUMINATION LIGHT ASSEMBLY
(a) Connect a positive (+) lead from the battery to terminal 2 and a negative (-) lead to terminal 1. |
|
(b) Check that the console box illumination light comes on.
OK:
Console box illumination light comes on.
Text in Illustration
*1 |
Component without harness connected (Console Box Illumination Light Assembly) |
If the result is not as specified, replace the console box illumination light assembly.
Installation
INSTALLATION
PROCEDURE
1. INSTALL CONSOLE BOX ILLUMINATION LIGHT ASSEMBLY
(a) Engage the 4 claws to install the 2 console box illumination light assemblies. |
|
2. INSTALL CONSOLE BOX WIRE
3. INSTALL CONSOLE MOUNTING RETAINER ASSEMBLY
4. INSTALL CONSOLE BOX ASSEMBLY
5. INSTALL NO. 2 CONSOLE BOX CARPET
6. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
Installation
INSTALLATION
PROCEDURE
1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
(a) Using a T30 "TORX" socket wrench, install the windshield wiper motor
assembly with the 2 bolts.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
...
Transfer Case Front Oil Seal(when Not Using The Engine Support Bridge)
Components
COMPONENTS
ILLUSTRATION
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE TRANSFER ASSEMBLY
(See page ).
2. REMOVE TRANSFER CASE FRONT OIL SEAL
(a) Using SST, remove the transfer case front oil seal from the transfer
case.
...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed
for that code. For details of the code, refer to "See page" in the DTC chart.
Inspect the fuses and relays before troub ...