Toyota Venza: Compressor(for 2gr-fe)

Installation

INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL LEVEL (a) When replacing the cooler compressor assembly with a new one, gradually discharge the inert gas (helium) from the service va ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Transfer Case Front Oil Seal(for Rh Side)
Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. DRAIN TRANSFER OIL (a) Remove the transfer drain plug and gasket to drain the transfer oil. (b) Install a new gasket and the transfer drain plug. Torque: 49 N·m {500 kgf ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HOOD SUB-ASSEMBLY (a) Check that the clearance measurements of areas *1 through *4 are within each standard range. Standard Clearance Area Measurement Area Measureme ...

Terminals Of Ecu
TERMINALS OF ECU 1. STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition D17-1 (GND) - Body ground ...