Toyota Venza: Components

Canister

...

Removal

REMOVAL PROCEDURE 1. REMOVE NO. 1 FLOOR UNDER COVER (a) Disengage the 4 nuts and clip, and remove the No. 1 floor under cover. Text in Illustration Nut (attached to under cov ...

Other materials about Toyota Venza:

Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) (P0031,P0032,P101D)
DESCRIPTION Refer to DTC P2195 (See page ). HINT: When any of these DTCs is stored, the ECM enters fail-safe mode. The ECM turns off the air fuel ratio sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

Precaution
PRECAUTION 1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected. System Name ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 3. REMOVE COOL AIR ...