Toyota Venza: Components

Valve Body Assembly(when Not Using The Engine Support Bridge)

...

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE TRANSMISSION WIRE 2. REMOVE ATF TEMPERATURE SENSOR ASSEMBLY (a) Remove the 4 bolts, ATF temperature sensor assembly and clamp from the valve body ...

Other materials about Toyota Venza:

High Mounted Stop Light Assembly
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE CENTER STOP LIGHT ASSEMBLY (a) Using a short screwdriver, remove the 2 screws. (b) Disconnect the connector and remov ...

Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT: Use an overhaul stand as necessary. PROCEDURE 1. INSTALL DIFFERENTIAL RING GEAR (a) Clean the contact surfaces of the rear differential case sub-assembly and differential ring gear. (b) Heat the differential ri ...

Installation
INSTALLATION PROCEDURE 1. INSTALL POWER BACK DOOR UNIT ASSEMBLY (a) Install the power back door unit with the 4 bolts. Torque: 13 N·m {133 kgf·cm, 10 ft·lbf} (b) Connect the connector. 2. ...