Toyota Venza: Components

Atf Temperature Sensor(when Not Using The Engine Support Bridge)

...

Removal

REMOVAL PROCEDURE 1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY HINT: See the steps from "Remove Engine Assembly with transaxle" through "Remove Automatic Transaxle Assembly" (See p ...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY (a) Inspect the shift lock operation. (1) Move the shift lever to P. (2) Turn the ignition switch off. (3) Check that the shift lever cannot be moved from P to any other position ...

ABS Warning Light Remains ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN communication. If any of the following is detected, the ABS warning light remains on: The skid control ECU connector is disconnected from the skid control ECU. The ...

Removal
REMOVAL PROCEDURE 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE See page for 2GR-FE See page for 1AR-FE 2. REMOVE FRONT NO. 1 STABILIZER BRACKET LH 3. REMOVE FRONT NO. 1 STABILIZER BRACKET RH HINT: Perform the same procedure as for the LH side. 4. REM ...