Toyota Venza: Components

Parking Brake Switch

...

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS sys ...

Other materials about Toyota Venza:

Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: When disconnecting the steering intermediate shaft assembly and pinion shaft of steering gear assembly, be sure to place matchmarks before servicing. PROCEDURE 1. INSTALL TIE ROD ASSEMBLY LH (a) I ...

Clock Display Circuit
DESCRIPTION The accessory meter assembly uses this circuit to communicate with the combination meter assembly via the direct line. The accessory meter assembly uses this circuit to receive the drive monitor switch signals from the combination meter assemb ...

Fuel Pump Control Circuit
DESCRIPTION 1. w/o Smart Key System When the engine is cranked, the starter relay drive signal output from the ignition switch is input into the STA terminal of the ECM, and the NE signal generated by the crankshaft position sensor is also input into the ...