Toyota Venza: Components

Lumbar Switch

...

Removal

REMOVAL PROCEDURE 1. REMOVE FRONT SEAT HEADREST ASSEMBLY 2. REMOVE FRONT SEAT REAR OUTER TRACK COVER 3. REMOVE FRONT SEAT REAR INNER TRACK COVER 4. REMOVE FRONT SEAT ASSEMBLY 5. REMOVE ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY (a) Install the spiral with sensor cable sub-assembly (See page ). NOTICE: Do not replace the spiral cable with the battery connected and the engine switch on (IG). ...

Installation
INSTALLATION PROCEDURE 1. INSTALL PARKING BRAKE SWITCH ASSEMBLY (a) Install the parking brake switch assembly with the screw. Torque: 0.9 N·m {9 kgf·cm, 8 in·lbf} 2. INSTALL PARKING BRAKE ...

Installing child restraints using a seat belt (child restraint lock function belt)
 - Rear-facing -- Infant seat/convertible seat Place the child restraint system on the rear seat facing the rear of the vehicle. Run the seat belt through the child restraint system and insert the plate into the buckle. Make sure that the belt is ...