Toyota Venza: Components

Drive Monitor Switch

...

Inspection

INSPECTION PROCEDURE 1. INSPECT DRIVE MONITOR SWITCH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condi ...

Other materials about Toyota Venza:

Registering ID codes
The tire pressure warning valve and transmitter is equipped with a unique ID code. When replacing a tire pressure warning valve and transmitter, it is necessary to register the ID code of tire pressure warning valve and transmitter. Have the ID code regi ...

Transmitter ID1 Error (C2141/41-C2144/44)
DESCRIPTION The tire pressure warning valve and transmitter installed in each tire and wheel assembly measures the tire pressures. The measured values are transmitted as radio waves to the tire pressure warning antenna and receiver on the body and then se ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MAGNETIC SWITCH ASSEMBLY (a) Remove the nut and disconnect the lead wire from the magnetic switch. (b) Remove the 2 screws holding the magnetic switch to t ...