Toyota Venza: Components

Front Evaporator Temperature Sensor

...

Removal

REMOVAL PROCEDURE 1. REMOVE AIR CONDITIONING UNIT ASSEMBLY (See page ) 2. REMOVE NO. 1 FINISH PANEL MOUNTING BRACKET 3. REMOVE NO. 2 FINISH PANEL MOUNTING BRACKET 4. REMOVE NO. 3 AIR DUCT ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY CAUTION / NOTICE / HINT NOTICE: Before installation, apply high temperature grease to the parts indicated by arrows (See page ). PROCEDURE 1. INSTALL NO. 2 PARKING BRAKE SHOE HOLD DOWN SPRING PIN (for 2WD) (a) Install the No. 2 p ...

Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (a) Align the splines of the shaft and install the drive shaft assembly LH using a brass bar and a hammer. NOTICE: Set the shaft snap ring with the opening fac ...

Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. Vehicles with smart key system: Turn the “ENGINE START STOP” switch off. Vehicles without smart key system: Turn th ...