Toyota Venza: Components

Blower Unit

...

Removal

REMOVAL PROCEDURE 1. REMOVE AIR CONDITIONING UNIT ASSEMBLY (See page ) 2. REMOVE NO. 1 FINISH PANEL MOUNTING BRACKET 3. REMOVE NO. 2 FINISH PANEL MOUNTING BRACKET 4. REMOVE NO. 3 AIR DUCT ...

Other materials about Toyota Venza:

Horn
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT LOW PITCHED HORN ASSEMBLY (a) Apply battery voltage and check the operation of the low pitched horn assembly according to the table below. OK: ...

Driver Side Door Entry Lock Function does not Operate
DESCRIPTION If the driver door entry unlock function operates normally, but its entry lock function does not, this means that the request code from the driver door is being output normally. In this case, a malfunction in the lock sensor circuit (from the ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FRONT AIRBAG SENSOR (a) Check that the ignition switch is off. (b) Check ...