Toyota Venza: Components

Sliding Roof Housing

...

Removal

REMOVAL PROCEDURE 1. REMOVE NO. 1 SLIDING ROOF GLASS SUB-ASSEMBLY (a) Fully open the No. 2 sliding roof glass sub-assembly. (b) Using a T20 "TORX" socket wrench, remove the 6 ...

Other materials about Toyota Venza:

System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main body ECU (Driver side junction block assembly) Power back door ECU (Power back door motor unit) ...

Operation Check
OPERATION CHECK 1. NOTICE WHEN CHECKING THE FOLLOWING (a) Power door lock/unlock function: This wireless door lock control function operates only when the following 3 conditions are met: (1) The engine switch is off. (2) All doors are closed. (3) The p ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE GENERATOR REAR END COVER (a) Remove the 3 nuts and generator rear end cover. 2. REMOVE TERMINAL INSULATOR (a) Remove the terminal insulator from the gener ...