Toyota Venza: Components

Outer Mirror Switch

...

Removal

REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH 2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL 4. REMOVE OUTER MIRROR SWITCH ASSEMBLY ...

Other materials about Toyota Venza:

Precaution
PRECAUTION 1. NOTICE FOR INITIALIZATION HINT: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See procedure Back Door ...

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. DTCs are displayed by blinking of the SRS warning light. HINT: When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or ...

Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. Vehicles with smart key system: Turn the “ENGINE START STOP” switch off. Vehicles without smart key system: Turn th ...