Toyota Venza: Components

Roof Drip Side Finish Moulding

...

Removal

REMOVAL PROCEDURE 1. REMOVE ROOF DRIP CENTER SIDE FINISH MOULDING (w/o Sliding Roof) (a) Put protective tape around the roof drip center side finish moulding. Text in Illustration ...

Other materials about Toyota Venza:

Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier
DESCRIPTION This circuit sends a signal to the stereo component amplifier assembly to mute noise. Due to this, the noise produced by changing the sound source ceases. If there is an open in the circuit, noise can be heard from the speakers when changing ...

Removal
REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ). If the front seat side airbag assembly was deployed, replace the front seat side airbag assembly, front seat frame assembly wit ...

Engine oil
With the engine at operating temperature and turned off, check the oil level on the dipstick.  - Checking the engine oil Park the vehicle on level ground. After warming up the engine and turning it off, wait more than five minutes for the oil to ...