Toyota Venza: Components

Power Back Door Drive Unit

...

Removal

REMOVAL PROCEDURE 1. REMOVE REAR DOOR SCUFF PLATE LH 2. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH 3. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 4. REMOVE DECK BOARD ASSEMBL ...

Other materials about Toyota Venza:

Precaution
PRECAUTION 1. PRECAUTION FOR DISCONNECTING THE BATTERY CABLE NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected: System See Procedure ...

Replacement
REPLACEMENT CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. DRAIN DIFFERENTIAL OIL 2. REMOVE REAR WHEEL 3. REMOVE CENTER EXHAUST PIPE ASSE ...

SRS Warning Light does not Come ON
DESCRIPTION The SRS warning light is located on the combination meter assembly. When the SRS is normal, the SRS warning light comes on for approximately 6 seconds after the ignition switch is turned from off to ON, and then goes off automatically. If ther ...