Toyota Venza: Components

Front Lower Ball Joint

...

Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT LOWER BALL JOINT (a) Inspect the turning torque of the ball joint. (1) Secure the front lower ball joint in a vise using aluminum plates. (2) ...

Other materials about Toyota Venza:

Cold Start Idle Air Control System Performance (P050A)
MONITOR DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC is stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the idl ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT (a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot. (b) Install the No. 2 ste ...

Installation
INSTALLATION PROCEDURE 1. INSPECT TORQUE CONVERTER ASSEMBLY 2. INSTALL TORQUE CONVERTER ASSEMBLY (a) Engage the splines of the input shaft and turbine runner. (b) Engage the splines o ...