Toyota Venza: Components

Engine Switch

...

Inspection

INSPECTION PROCEDURE 1. INSPECT ENGINE SWITCH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condi ...

Other materials about Toyota Venza:

Short in GPS Antenna (B15C0,B15C1)
DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. DTC Detection Condition Trouble Area B15C0 Navigation antenna malfunction ...

Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 MANIFOLD CONVERTER INSULATOR (a) Install the No. 1 manifold converter insulator to the exhaust manifold converter sub-assembly with the 4 bolts. Torque: 12 N·m {122 kgf·cm, 9 ft·lbf} ...

Power Seat does not Return to Memorized Position
DESCRIPTION When either the M1 or M2 switch is pressed, the outer mirror control ECU assembly LH sends a switch signal to the main body ECU (driver side junction block assembly) via CAN communication. Then, the main body ECU (driver side junction block as ...