Toyota Venza: Components

Camshaft

...

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RE ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL LH 2. REMOVE FRONT FENDER OUTSIDE MOULDING LH 3. REMOVE FRONT FENDER LINER LH (a) Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips. Text in Illustration ...

Cellular Phone Registration Failure
PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updating software, etc. is necessary, make sure to obtain the per ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR DRIVE SHAFT DUST COVER (a) Using SST and a steel plate, install a new rear drive shaft dust cover to the rear drive shaft inboard joint assembly. Text in Illustration *1 ...