Toyota Venza: Clearance Warning ECU Power Source Circuit

Toyota Venza Service Manual / Park Assist / Monitoring / Intuitive Parking Assist System / Clearance Warning ECU Power Source Circuit

DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.	CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY POWER SOURCE)

(a) Disconnect the D79 clearance warning ECU assembly connector.

(b) Measure the voltage according to the value(s) is the table below.

Standard Voltage:

Tester Connection	Condition	Specified Condition
D79-1 (IG) - Body ground	Engine switch on (IG)	11 to 14 V
D79-1 (IG) - Body ground	Engine switch off	Below 1 V

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.	CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
D79-30 (E) - Body ground	Always	Below 1 Ω

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

REPAIR OR REPLACE HARNESS OR CONNECTOR

Clearance Warning Buzzer Circuit

DESCRIPTION This circuit consists of the No. 1 clearance warning buzzer and clearance warning ECU assembly. An ECU-excited type buzzer is used. The ECU operates the buzzer using a sound pattern t ...

Rear View Monitor System

...

Other materials about Toyota Venza:

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the wiper and washer system. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

Audio Receiver Assembly Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Audio Receiver Assembly Communication Stop Mode "Display and Navigation (AVN1)" is not displayed on the "CAN Bus Check ...

Installation
INSTALLATION PROCEDURE 1. INSTALL ATF TEMPERATURE SENSOR ASSEMBLY (a) Coat a new O-ring with ATF and install it to the ATF temperature sensor assembly. Text in Illustration *1 O-ring ...