Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET
(a) Engage the guide. |
|
(b) Install the child restraint seat tether anchor bracket with the bolt.
Torque:
31 N·m {316 kgf·cm, 23 ft·lbf}
HINT:
Use the same procedure for the other 2 child restraint seat tether anchor brackets.
2. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY
3. INSTALL NO. 1 DECK BOARD
4. INSTALL DECK SIDE TRIM BOX RH
5. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY
6. INSTALL DECK SIDE TRIM BOX LH
7. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
8. INSTALL DECK BOARD ASSEMBLY
Removal
REMOVAL
PROCEDURE
1. REMOVE DECK BOARD ASSEMBLY
2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY
3. REMOVE DECK SIDE TRIM BOX LH
4. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY
5. REMOVE DECK SIDE TRIM BOX RH
6. REMOVE NO. 1 DECK BOARD
7. REMOVE REAR SEAT SUB FLOOR PANEL ASSEMBLY
8. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET
(a) Remove the bolt. |
|
(b) Disengage the guide and remove the child restraint seat tether anchor bracket.
HINT:
Use the same procedure for the other 2 child restraint seat tether anchor brackets.
Inspection
INSPECTION
PROCEDURE
1. INSPECT THERMOSTAT
HINT:
The valve opening temperature is inscribed on the thermostat.
(a) Immerse the thermostat in water, and then gradually heat the water.
(b) Check t ...
Engine Coolant Temperature Circuit Malfunction (P0115,P0117,P0118)
DESCRIPTION
A thermistor, whose resistance value varies according to the engine coolant temperature,
is built into the engine coolant temperature sensor.
The structure of the sensor and its connection to the ECM are similar to those
of the intake air tem ...
Drive Belt
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT V-RIBBED BELT
(a) Check the belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the V-r ...