Toyota Venza: Check For Intermittent Problems

Toyota Venza Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / Check For Intermittent Problems

CHECK FOR INTERMITTENT PROBLEMS

1. CHECK FOR INTERMITTENT PROBLEMS

HINT:

A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected using the ECU Data List function of the Techstream.

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(d) Turn the Techstream on.

(e) Follow the directions on the Techstream to display the Data List and select areas where momentary interruption should be monitored.

HINT:

A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
If the status remains on (Error displayed), check the continuity between the ECU and the sensors, or between ECUs.
The Error display on the Techstream remains on for 1 second after the harness signal changes from momentary interruption (open circuit) to normal.

ABS/VSC/TRAC

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
EFI Communication Open	EFI communication open detection / Error or Normal	Error: Momentary interruption Normal: Normal	-
Yaw Rate Open	Yaw rate sensor open detection / Error or Normal	Error: Momentary interruption Normal: Normal	-
Deceleration Open	Acceleration sensor open detection / Error or Normal	Error: Momentary interruption Normal: Normal	-
Steering Open	Steering angle sensor open detection / Error or Normal	Error: Momentary interruption Normal: Normal	-
IG Voltage Value Decreased	IG voltage value decrease detection / Error or Normal	Error: Decrease Normal: Normal	-
FR Speed Sensor Voltage Open	Front speed sensor RH voltage open detection / Error or Normal	Error: Momentary interruption Normal: Normal	-
FL Speed Sensor Voltage Open	Front speed sensor LH voltage open detection / Error or Normal	Error: Momentary interruption Normal: Normal	-
RR Speed Sensor Voltage Open	Rear speed sensor RH voltage open detection / Error or Normal	Error: Momentary interruption Normal: Normal	-
RL Speed Sensor Voltage Open	Rear speed sensor LH voltage open detection / Error or Normal	Error: Momentary interruption Normal: Normal	-

(f) While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

OK:

Normal display appears.

HINT:

The connector and/or wire harness has a momentary interruption (open circuit) if the display changes. Repair or replace the connector and/or wire harness as one of them is faulty.

Calibration

CALIBRATION 1. DESCRIPTION (a) Follow the chart below to perform calibration. Parts to be Replaced Necessary Operation Brake actuator assembly (Skid control E ...

Test Mode Procedure

TEST MODE PROCEDURE 1. WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK (a) Release the parking brake. NOTICE: Before releasing the parking brake, move the shift lever to P for safety. HINT: When ...

Other materials about Toyota Venza:

Rear Light Assembly
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REAR LIGHT ASSEMBLY (a) Disconnect the connector from the rear light assembly. (b) Measu ...

Installation
INSTALLATION PROCEDURE 1. INSTALL SHIFT LEVER ASSEMBLY NOTICE: Check that the park/neutral position switch and the shift lever are in neutral. (a) Slide the slider of the transmission control cable in the direction indicated by the arrow an ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: The front side fix window assembly can be reused. When installing the window, if any of the clips on the front side fix window assembly are broken, butyl tape can be used to support the glass until the a ...