General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. INSPECT STEERING LINKAGE AND GEAR HOUSING
(a) Check the steering wheel free play (See page ).
(b) Check the steering linkage for looseness or damage.
(1) Check that the tie rod ends do not have any play.
(2) Check that the dust seals and boots are not damaged.
(3) Check that the boot clamps are not loose.
(4) Check that the steering gear housing is not damaged.
2. INSPECT BALL JOINTS AND DUST COVERS
(a) Inspect the ball joints for looseness.
(1) Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.
(2) Lower the vehicle until the front coil spring has about half its ordinary load. Place stands under the vehicle for safety.
(3) Check that the front wheels are pointing straight ahead. Use wheel chocks on all 4 wheels.
(4) Using a lever, pry up the end of the lower arm. Check the amount of play.
Maximum ball joint vertical play:
0 mm (0 in.)
If there is any play, replace the ball joint.
(b) Check the dust cover for damage.
3. INSPECT DRIVE SHAFT BOOTS
(a) Check the drive shaft boots for loose clamps, cracks, grease leaks, kinks or damage.
4. INSPECT TRANSAXLE FLUID
(a) Visually check the transaxle for fluid leaks. If fluid is leaking, find the cause and repair it.
5. INSPECT TRANSFER OIL (for AWD)
(a) Visually check the transfer for fluid leaks. If fluid is leaking, find the cause and repair it.
6. INSPECT REAR DIFFERENTIAL OIL (for AWD)
(a) Visually check the rear differential for fluid leaks. If fluid is leaking, find the cause and repair it.
7. INSPECT FRONT AND REAR SUSPENSION
(a) Check the front and rear suspension.
Type |
See Procedure |
---|---|
Front Suspension |
See page |
Rear Suspension |
See page |
8. TIGHTEN PROPELLER SHAFT BOLTS (for AWD)
(a) Tighten the bolts for the propeller shaft (See page ).
Brake Switch "B" Circuit High (P0724)
DESCRIPTION
The purpose of this circuit is to prevent the engine from stalling when the brakes
are suddenly applied while driving in the lock-up condition.
When the brake pedal is depressed, this switch sends a signal to the TCM. Then
the TCM cancels the ...
Cursor or Map Rotates when Vehicle Stopped
PROCEDURE
1.
CHECK CONDITION
(a) Check with the customer if the vehicle has been turned by a turntable.
OK:
Vehicle has not been turned by a turntable.
HINT:
If the vehicle is turned on a turntable with ...
Noise Occurs or Sound Skips when Portable Player Plays
CAUTION / NOTICE / HINT
HINT:
Perform this check with the portable player volume set at an appropriate
level.
Make sure that there are no obstructions between the portable player
and the radio and display receiver assembly that may block ...