PROCEDURE
1. |
CHECK LOCK FUNCTION OF GENERATOR CLUTCH PULLEY |
(a) Check the lock function with the pulley installed in the vehicle.
(1) Visually check that the rotor in the generator operates with the engine running.
(b) Check the lock function with the pulley removed from the vehicle.
(1) Remove the generator pulley cap.
(2) Hold the generator rotor using SST, and turn the clutch pulley clockwise to check that the outer ring locks (See page ). Text in Illustration
OK: The outer ring locks. |
|
SST: 09820-63021
NG |
REPLACE GENERATOR CLUTCH PULLEY |
|
2. |
CHECK INSTALLATION OF GENERATOR CLUTCH PULLEY |
(a) Start the engine and visually check the clutch pulley for looseness.
OK:
The clutch pulley is not loose.
OK |
REPLACE GENERATOR ASSEMBLY |
NG |
TIGHTEN GENERATOR CLUTCH PULLEY TO THE SPECIFIED TORQUE |
Drive Belt
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT V-RIBBED BELT
(a) Check the belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the V-r ...
Disposal
DISPOSAL
CAUTION / NOTICE / HINT
CAUTION:
Before performing pre-disposal deployment of any SRS component, review and closely
follow all applicable environmental and hazardous material regulations. Pre-disposal
deployment may be considered hazardous mate ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT DRIVER SIDE SEAT BELT WARNING
(a) Turn the ignition switch to ON.
(b) When the driver side seat belt is not fastened, check that the driver side
seat belt warning light on the combination meter assembly blinks.
...