DESCRIPTION
This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the navigation system vehicle customization screen.
HINT:
The certification ECU (smart key ECU assembly) controls the smart key system related items that are customizable via the navigation system vehicle customization screen.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B15F7 |
Certification ECU (smart key ECU assembly) vehicle setting processing malfunction |
|
CAUTION / NOTICE / HINT
NOTICE:
Before replacing the certification ECU (smart key ECU assembly), refer to Registration (See page ).
PROCEDURE
1. |
CHECK CAN COMMUNICATION SYSTEM |
(a) Use the Techstream to check if the CAN communication system is functioning normally (See page ).
OK:
CAN communication DTCs are not output.
NG |
GO TO CAN COMMUNICATION SYSTEM |
|
2. |
CHECK SMART KEY SYSTEM |
(a) for Entry Function:
Check if the smart key system is malfunctioning (See page ).
for Start Function:
Check if the smart key system is malfunctioning (See page ).
HINT:
Customization may not be possible depending on the malfunction in the smart key system.
OK:
No malfunctions are present in the smart key system.
(b) Proceed to the next step based on the check result.
Result |
Proceed to |
---|---|
OK |
A |
NG (for Entry Function) |
B |
NG (for Start Function) |
C |
B |
GO TO SMART KEY SYSTEM (for Entry Function) |
C |
GO TO SMART KEY SYSTEM (for Start Function) |
|
3. |
CHECK CUSTOMIZE ITEMS |
(a) Make a note of the customizable items for the certification ECU (smart key ECU assembly) related system.
HINT:
The items shown as customizable via the navigation system vehicle customization screen can also be changed using the Techstream. In the following step, the Techstream will be used.
(1) To match-up the items on the navigation system vehicle customization screen
with the items on the Techstream, check the customize parameters list for the smart
key system (for Entry Function) related items that can be customized via the navigation
system vehicle customization screen (See page
).
(2) To match-up the items on the navigation system vehicle customization screen
with the items on the Techstream, check the customize parameters list for the smart
key system (for Start Function) related items that can be customized via the navigation
system vehicle customization screen (See page
).
(b) Using the Techstream, confirm that it is possible to change the settings of the customize parameters that are available for customization via the navigation system vehicle customization screen.
OK:
The items available for customization via the navigation system vehicle customization screen can be customized successfully using the Techstream.
OK |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
NG |
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 3 ANTENNA CORD SUB-ASSEMBLY
2. INSTALL ROOF HEADLINING ASSEMBLY
HINT:
Refer to the procedure from Install Roof Headlining Assembly (See page
).
3. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY
4. INSTALL REAR ...
Intake Air Temperature Circuit Low Input (P0112,P0113)
DESCRIPTION
The intake air temperature sensor, in the mass air flow meter, monitors
the intake air temperature. The intake air temperature sensor has a built-in
thermistor with a resistance that varies according to the temperature of
the ...
Lost Communication with AFS LIN (B124D)
DESCRIPTION
Refer to DTC B124D (Lighting system) (See page
).
DTC No.
DTC Detection Condition
Trouble Area
B124D
Malfunctions in LIN communication system
Inner rear view mir ...