DESCRIPTION
Detection Item |
Symptom |
Trouble Area |
---|---|---|
Center Airbag Sensor Communication Stop Mode |
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
HINT:
PROCEDURE
1. |
CHECK CAN BUS WIRE FOR DISCONNECTION (CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE) |
(a) Turn the ignition switch off.
(b) Disconnect the connector of the center airbag sensor assembly. Text in Illustration
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
D6-13 (CANH) - D6-22 (CANL) |
Ignition switch off |
54 to 69 Ω |
NG |
REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE) |
|
2. |
CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
(a) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT) |
|
3. |
CHECK HARNESS AND CONNECTOR (GROUND TERMINAL) |
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
OK |
REPLACE CENTER AIRBAG SENSOR ASSEMBLY |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT) |
Relay
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. FAN NO. 1 RELAY
(a) Remove the relay from the engine room relay block.
(b) Measure the resistance according to the value(s) in the table b ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL GENERATOR ROTOR ASSEMBLY
(a) Place the generator drive end frame on the generator pulley.
(b) Install the generator rotor to the generator drive end frame.
...
Automatic transmission
Select a shift position appropriate for the driving conditions.
- Shifting the shift lever
Vehicles with smart key system:
While the “ENGINE START STOP” switch is in IGNITION ON mode, depress the brake
pedal and move the shift lever.
Vehicles ...