Toyota Venza: Cellular Phone Inspection

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / Cellular Phone Inspection

PROCEDURE

1.	CHECK USAGE CONDITION

(a) Check that the vehicle and cellular phone meet the following conditions:

NOTICE:

If changing cellular phone settings, updating software, etc. is necessary, make sure to obtain the permission of the customer before performing it.

The cellular phone is "Bluetooth" compatible (See page ).

The cellular phone is registered as a hands-free device.
"Bluetooth" setting of the cellular phone is on.
Operating system and software of the cellular phone are the latest versions.
There are no other radio wave emitting devices ("Wi-Fi" communication device, etc.) in the cabin.

(b) Connect the cellular phone to the in-vehicle device and check that it is connected correctly.

Result	Proceed to
The cellular phone is connected correctly.	A
The cellular phone is not connected correctly.	B

END

2.	RESTART CELLULAR PHONE

(a) Restart the cellular phone.

(b) Turn the ignition switch off.

(d) Connect the cellular phone to the in-vehicle device and check that it is connected correctly.

Result	Proceed to
The cellular phone is connected correctly.	A
The cellular phone is not connected correctly.	B

END

3.	CHECK OPERATION

(a) Check if the in-vehicle device can be recognized by the cellular phone.

Result	Proceed to
In-vehicle device can be recognized.	A
In-vehicle device cannot be recognized.	B

GO TO STEP 5

4.	REGISTER AGAIN

(a) Clear all "Bluetooth" devices registered to the cellular phone and navigation receiver assembly.

(b) Register the cellular phone again.

Result	Proceed to
The cellular phone is connected correctly.	A
The cellular phone is not connected correctly.	B

END

5.	CHECK USING ANOTHER VEHICLE

(a) Check if the customer's cellular phone functions normally using another "Bluetooth" compatible vehicle.

HINT:

Make sure to obtain the customer's permission to perform this procedure.
After the inspection, clear the registered information and usage history acquired during the inspection.

Result	Proceed to
The cellular phone is connected correctly.	A
The cellular phone is not connected correctly.	B

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

6.	CHECK USING ANOTHER CELLULAR PHONE

(a) Check if the system functions normally using another "Bluetooth" compatible cellular phone.

HINT:

Make sure to obtain the customer's permission to perform this procedure.
After the inspection, clear the registered information and usage history acquired during the inspection.

Result	Proceed to
The cellular phone is connected correctly.	A
The cellular phone is not connected correctly.	B

END (ONLY A "Bluetooth" COMPATIBLE CELLULAR PHONE CAN BE USED)

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Voice is not Recognized

PROCEDURE 1. CHECK CONDITION (a) Check if the system voice recognition level is low when recognizing a particular voice. Result Proceed to ...

Cellular Phone Registration Failure

PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updatin ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT POWER SEAT SWITCH LH (w/o Seat Position Memory System) (a) Measure the resistance between the terminals when each switch is operated. Standard Resistance: Slide Switch Tester Co ...

XM Tuner Antenna Disconnected (B15FE,B15FF)
DESCRIPTION These DTCs are stored when a malfunction occurs in the roof antenna assembly which is connected to the stereo component tuner assembly. DTC No. DTC Detection Condition Trouble Area B15FE ...

System Description
SYSTEM DESCRIPTION 1. GENERAL This system has the following functions: manual slide open and close; auto slide open; manual tilt up and down; auto tilt up; jam protection; key off operation. 2. FUNCTION OF MAIN COMPONENT Component O ...