Toyota Venza: CD Sound Skips

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / CD Sound Skips

PROCEDURE

CHECK CD

(a) Check that the CD is not deformed or cracked.

OK:

No deformation or cracks on the CD.

END (CD IS FAULTY)

CHECK CD

(a) Check the CD.

OK:

The CD is clean.

NOTICE:

Do not use a conventional record cleaner or anti-static preservative.

HINT:

If dirt is on the CD surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

CLEAN CD

3.	REPLACE CD AND RECHECK

(a) Replace the CD with a new or known good one and check that the malfunction disappears.

OK:

Malfunction disappears.

END (CD WAS FAULTY)

4.	CHECK NAVIGATION RECEIVER ASSEMBLY

(a) Check the navigation receiver assembly installation condition.

(1) Check that the navigation receiver assembly is properly installed.

OK:

The navigation receiver assembly is properly installed.

REPLACE NAVIGATION RECEIVER ASSEMBLY

REINSTALL NAVIGATION RECEIVER ASSEMBLY

CD cannot be Inserted or is Ejected Right After Insertion

PROCEDURE 1. CHECK IF A PROPER CD IS INSERTED (a) Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC files, and that it is not deformed, flawed, s ...

Illumination for Panel Switch does not Come on with Tail Switch ON

PROCEDURE 1. CHECK VEHICLE SIGNAL (OPERATION CHECK) (a) Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operati ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (a) Apply positive (+) battery voltage to connector terminal 2 (B). NOTICE: Do not apply positive (+) battery voltage to any terminals other than terminal 2 ...

Registering ID codes
The tire pressure warning valve and transmitter is equipped with a unique ID code. When replacing a tire pressure warning valve and transmitter, it is necessary to register the ID code of tire pressure warning valve and transmitter. Have the ID code regi ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH (a) Temporarily install the rear No. 1 suspension arm assembly LH to the rear suspension member with the bolt and the nut. Text in Illustration *1 ...