Toyota Venza manuals

Toyota Venza: CD cannot be Ejected

PROCEDURE

1.

CHECK OPERATION

(a) Press the disc eject switch of the radio and display receiver assembly for 5 seconds or more and check that the CD is ejected.

OK:

CD is ejected.


NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY


OK

2.

REPLACE CD AND RECHECK

(a) Replace the CD with a known good one and check that the malfunction disappears.

OK:

CD is ejected.


OK

END (CD WAS FAULTY)


NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

Sound Quality is Bad Only when CD is Played (Volume is Too Low)
PROCEDURE 1. REPLACE CD AND RECHECK (a) Replace the CD with a known good one and check that the malfunction disappears. OK: Malfunction disappears. OK ...

CD cannot be Inserted / Played or CD is Ejected Right After Insertion
PROCEDURE 1. CHECK IF A PROPER CD IS INSERTED (a) Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC file, and that it is not deformed, flawed, st ...

Other materials about Toyota Venza:

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the rear view monitor system seems to be malfunctioning, use the Techstream to check for malfunctions and to perfor ...

Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 FUEL TANK CUSHION (a) Install 8 new No. 1 fuel tank cushions to the fuel tank. 2. INSTALL FUEL MAIN TUBE SUPPORT (a) Install the fuel main tube su ...

Installation
INSTALLATION PROCEDURE 1. TEMPORARILY INSTALL SLIDING ROOF HOUSING ASSEMBLY (a) Temporarily install the sliding roof housing panel with the 18 nuts. NOTICE: When installing the housing to the vehicle, first install the housing center front and ...

© 2016-2024 Copyright www.tovenza.com

0.1311