Toyota Venza: BUS IC Communication Malfunction (B1497/97)

Toyota Venza Service Manual / Heating / Air Conditioning / Air Conditioning System / BUS IC Communication Malfunction (B1497/97)

DESCRIPTION

The air conditioning harness connects the A/C amplifier and each servo. The A/C amplifier supplies power and sends operation instructions to each servo through the air conditioning harness. Each servo sends the damper position information to the A/C amplifier.

DTC No.	DTC Detection Condition	Trouble Area
B1497/97	Communication line error or open	Air conditioning harness A/C amplifier

WIRING DIAGRAM

PROCEDURE

1.	INSPECT A/C AMPLIFIER

(a) Remove the A/C amplifier with the connectors still connected.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
z7-2 (BUS G) - Body ground	Always	Below 1 Ω

Text in Illustration

*1	Component with harness connected (A/C Amplifier)

REPLACE A/C AMPLIFIER

2.	INSPECT A/C AMPLIFIER

(a) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection	Condition	Specified Condition
z7-4 (B BUS) - z7-2 (BUS G)	Ignition switch off	Below 1 V
z7-4 (B BUS) - z7-2 (BUS G)	Ignition switch ON	11 to 14 V
z7-3 (BUS) - z7-2 (BUS G)	Ignition switch ON	Pulse generation

Text in Illustration

*1	Component with harness connected (A/C Amplifier)

REPLACE AIR CONDITIONING HARNESS

REPLACE A/C AMPLIFIER

Compressor Solenoid Circuit (B1451/51)

DESCRIPTION In this circuit, the A/C compressor receives a refrigerant compression demand signal from the A/C amplifier. Based on this signal, the A/C compressor changes the amount of compressor o ...

Air Mix Damper Control Servo Motor Circuit (Driver Side) (B1446/46)

DESCRIPTION The air mix control servo motor sends pulse signals to indicate the damper position to the A/C amplifier. The A/C amplifier activates the motor (normal or reverse) based on these sign ...

Other materials about Toyota Venza:

Coolant
Replacement REPLACEMENT PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER 2. REMOVE NO. 2 ENGINE UNDER COVER 3. DRAIN ENGINE COOLANT (a) Loosen the radiator drain cock plug and drain the coolant. NOTICE: Do not remove the reserve tank cap or radiator drai ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) (a) Disconnect the 2A and 2F main body ECU (driver side junction block assembly) connectors. (b) Measure the voltage and resistance according to the value(s) in the table be ...

Torque Sensor Zero Point Adjustment Incomplete (C1516,C1526)
DESCRIPTION These DTCs do not indicate a malfunction. The power steering ECU stores these DTCs when it determines that the rotation angle sensor value initialization and torque sensor zero point calibration are incomplete. DTC No. D ...