Toyota Venza: Brake Pedal

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY (a) Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new brake master cylinder rese ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Push Switch / Key Unlock Warning Switch Malfunction (B2780)
DESCRIPTION This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is ON even when the ignition switch is ON. Under normal conditions, the unlock warning switch assembly is ON when the ignition switc ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON and turn the Techstream on. (c) Enter the following menus: Body Electrical / Trouble Codes. (d) Check for DTCs. 2. CLEAR DTC (a) Connect the Techst ...

Removal
REMOVAL PROCEDURE 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (for 2GR-FE) HINT: Refer to the procedure up to Remove Engine Assembly with Transaxle (See page ). 2. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (for 1AR-FE) HINT: Refer to the procedure up to Remo ...