Toyota Venza: Brake Line

NOTICE:

• Since the brake lines are critical safety related parts, be sure to disassemble and inspect the components if a brake fluid leak is found. If any abnormality is found, replace the component with a new one.
• When removing brake components, cover the brake line connections to prevent foreign matter such as dust or dirt from entering the lines.
• Do not damage or deform the brake lines during the removal and installation procedures.
• When installing a grommet to the body, ensure that the brake line passes through the center of the grommet.
• When installing a brake line or flexible hose, ensure that they are free from twists or bends.
• If the metal end of a flexible hose does not match the groove on the bracket, twist the hose slightly to insert it.
• Flexible hoses must be free from shock absorber oil, grease, etc.
• When installing a brake line to a plastic clamp, ensure that the brake line is not loose or pinched.
• Do not reuse any clips or plastic clamps removed from a flexible hose.
• After installing a brake line or flexible hose, ensure that they do not interfere with any other components or body.
• Do not allow brake fluid on any painted vehicle body surface. If brake fluid leaks onto any painted surface, immediately wash it off.
• When disconnecting and connecting a flexible hose and brake line:
  
  1. Hold the flexible hose with a wrench and disconnect the brake tube using a union nut wrench without deforming the tube.
  2. Remove the clip and disconnect the flexible hose.
  3. Secure the flexible hose with a new clip. At this time, be sure to securely install the clip.
  4. Connect the brake tube using a union nut wrench without deforming the tube.
• When connecting a brake line and way: Text in illustration
  

  *1	Hold
  *2	Turn

  1. Support the way to prevent the brake tubes from being deformed and connect each brake tube using a union nut wrench.
  2. Support the way to prevent the brake lines from being deformed and install the way to the vehicle body with the bolt.

Bleeding

BLEEDING CAUTION / NOTICE / HINT NOTICE: Do not allow brake fluid to adhere to any painted surface such as the vehicle body. If brake fluid leaks onto any painted surface, immediately ...

Brake Master Cylinder

...

Other materials about Toyota Venza:

Door Control Transmitter(w/o Smart Key System)
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE TRANSMITTER HOUSING COVER 2. REMOVE DOOR CONTROL TRANSMITTER MODULE Inspection INSPECTION PROCEDURE 1. INSPECT DOOR CONTROL TRANSMITTER (a) Inspect operation of th ...

Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device
PROCEDURE 1. CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL (a) Check if track information is displayed normally on another "Bluetooth" audio compatible vehicle of the same model. ...

Terminals Of Ecu
TERMINALS OF ECU 1. CLEARANCE WARNING ECU ASSEMBLY (a) Disconnect the D79 clearance warning ECU assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Wiring ...