General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. INSPECT BRAKE LINE PIPES AND HOSES
HINT:
Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.
(a) Using a mirror, check the entire circumference and length of the brake lines and hoses for:
(b) Check all the clamps for tightness and check the connections for leaks.
(c) Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system.
(d) Check that the lines are installed properly and pass through the center of the grommets.
2. INSPECT BRAKE PEDAL
(a) Check the brake pedal (See page ).
3. INSPECT PARKING BRAKE
(a) Check the parking brake shoe clearance and parking brake pedal travel (See page ).
(b) Check the parking brake cables to ensure that they are not deformed or binding.
4. INSPECT BRAKE LININGS AND DRUMS
(a) Check the parking brake linings and drums.
5. INSPECT FRONT BRAKE
(a) Check the front brake pads and discs (See page ).
6. INSPECT REAR BRAKE
(a) Check the rear brake pads and discs (See page ).
7. INSPECT OR CHANGE BRAKE FLUID
(a) Inspect or change the brake fluid (See page ).
Fluid:
SAE J1703 or FMVSS No. 116 DOT3
Lost Communication with Front Airbag Sensor LH (B1617/84,B1618/84)
DESCRIPTION
The front airbag sensor LH circuit consists of the center airbag sensor assembly
and front airbag sensor LH.
The front airbag sensor LH detects impacts to the vehicle and sends signals to
the center airbag sensor assembly to determine if the ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT DOOR LOCK ASSEMBLY LH
(a) Check the operation of the door lock motor.
(1) Apply battery voltage and check the operation of the door lock motor.
OK:
Measurement Condition
...
System Diagram
SYSTEM DIAGRAM
Transmitting ECU
(Transmitter)
Receiving ECU
Signal
Communication Method
ECM
Power Steering ECU
Engine speed signal
Engine variation inform ...