Toyota Venza: Basic Inspection

Toyota Venza Service Manual / 1ar-fe Engine Control / Sfi System / Basic Inspection

BASIC INSPECTION

When the malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following procedure, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when engine troubleshooting.

1. 1.CHECK BATTERY VOLTAGE

NOTICE:

Carry out this check with the engine stopped and the ignition switch off.

Result	Proceed to
11 V or more	GO TO STEP 2
Below 11 V	CHARGE OR REPLACE BATTERY

2. 2.CHECK WHETHER ENGINE CRANKS

Result	Proceed to
NG	PROCEED TO PROBLEM SYMPTOMS TABLE
OK	GO TO STEP 3

3. 3.CHECK WHETHER ENGINE STARTS

Result	Proceed to
NG	GO TO STEP 6
OK	GO TO STEP 4

4. 4.CHECK AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

(a) Visually check that the air cleaner filter element sub-assembly is not excessively contaminated with dirt or oil.

Result	Proceed to
NG	REPLACE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
OK	GO TO STEP 5

5. 5.CHECK IDLE SPEED

Result	Proceed to
NG	TROUBLESHOOT IDLE SPEED AND PROCEED TO NEXT STEP
OK	GO TO STEP 6

6. 6.CHECK FUEL PRESSURE

Result	Proceed to
NG	TROUBLESHOOT FUEL PRESSURE AND PROCEED TO NEXT STEP
OK	GO TO STEP 7

7. 7.CHECK FOR SPARK

Result	Proceed to
NG	TROUBLESHOOT IGNITION SYSTEM AND PROCEED TO NEXT STEP
OK	PROCEED TO PROBLEM SYMPTOMS TABLE

System Diagram

SYSTEM DIAGRAM ...

Check For Intermittent Problems

CHECK FOR INTERMITTENT PROBLEMS HINT: Inspect the ECM using check mode. Intermittent problems are easier to detect with the Techstream when the ECM is in check mode. In check mode, the ECM uses 1 ...

Other materials about Toyota Venza:

Registered Device cannot be Deleted
PROCEDURE 1. DELETE OPERATION (a) Check if a registered portable player can be deleted normally. OK: Registered portable player can be deleted normally. OK END NG PROCEED TO ...

Security Horn Circuit
DESCRIPTION When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU (driver side junction block assembly) controls the security horn. WIRING DIAGRAM PROCEDURE 1. PERFORM A ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of ...