DESCRIPTION
Refer to "AWD Warning Light Remains ON" (See page ).
WIRING DIAGRAM
Refer to "AWD Warning Light Remains ON" (See page ).
CAUTION / NOTICE / HINT
Check the condition of each related circuit connector before troubleshooting (See page ).
PROCEDURE
1. |
CHECK CAN COMMUNICATION SYSTEM |
(a) Check if the CAN communication system DTC is output.
Result |
Proceed to |
---|---|
CAN communication system DTC is not output |
A |
CAN communication system DTC is output |
B |
HINT:
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.
B |
REPAIR CAN COMMUNICATION SYSTEM |
|
2. |
INSPECT AWD WARNING LIGHT |
(a) Disconnect the AWD control ECU connector.
(b) Turn the ignition switch to ON.
(c) Check that the AWD warning light comes on.
OK:
AWD warning light comes on.
OK |
REPLACE AWD CONTROL ECU |
NG |
GO TO METER / GAUGE SYSTEM |
Installation
INSTALLATION
PROCEDURE
1. INSTALL HEADLIGHT ASSEMBLY
(a) Connect each connector.
(b) Install the headlight assembly with the bolt and 3 screws.
Torque:
3.6 N·m {37 kgf·cm, 32 in·lbf}
2. INSTALL FRONT BUMPER ASSEMBLY
(See page )
3. CONNECT CABLE T ...
Pressure Control Solenoid "A" Electrical (Shift Solenoid Valve SL1) (P0748)
DESCRIPTION
Changing from 1st to 6th is performed by the TCM turning shift solenoid valves
SL1, SL2, SL3, SL4 and SL on and off. If an open or short circuit occurs in any
of the shift solenoid valves, the TCM controls the remaining normal shift solenoid
...
Pressure Control Solenoid "C" Performance (Shift Solenoid Valve SL3) (P0796)
SYSTEM DESCRIPTION
The TCM uses the vehicle speed signal and signals from the transmission speed
sensors (NC, NT) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear).
Then the TCM compares the actual gear with the shift schedule in the TCM memo ...