Toyota Venza: Automatic High Beam System (B124B)

Toyota Venza Service Manual / Lighting (ext) / Lighting System / Automatic High Beam System (B124B)

DESCRIPTION

The DTC is stored when the main body ECU (driver side junction block assembly) detects malfunctions in the automatic high beam system.

DTC No.	DTC Detection Condition	Trouble Area
B124B	Malfunction in automatic high beam system	Steering angle sensor, VSC system or EFI system Inner rear view mirror assembly

CAUTION / NOTICE / HINT

NOTICE:

First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this symptom.

PROCEDURE

1.	CHECK FOR DTC

(a) Clear the DTCs (See page ).

(b) Check for DTCs (See page ).

OK:

DTC B124B is not output.

USE SIMULATION METHOD TO CHECK

2.	CHECK FOR DTC

(a) Check for DTCs (See page ).

Result	Proceed to
DTC B2414 is output	A
DTC B2415 is output	B
DTC U0126, DTC U0129 or DTC U0101 is output	C
Other DTC is not output	D

GO TO DTC CHART

REPLACE INNER REAR VIEW MIRROR ASSEMBLY

Automatic High Beam Mirror (B124A)

DESCRIPTION The DTC is stored when the main body ECU (driver side junction block assembly) detects malfunctions in the inner rear view mirror assembly. DTC No. DTC Detection ...

Automatic High Beam Camera (B124C)

DESCRIPTION The DTC is stored when the main body ECU (driver side junction block assembly) detects malfunctions in the camera (inner rear view mirror assembly). DTC No. DTC D ...

Other materials about Toyota Venza:

Short in GPS Antenna (B15C0,B15C1)
DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. DTC Detection Condition Trouble Area B15C0 Navigation antenna malfunction ...

Engine Coolant Temperature Circuit Range / Performance Problem (P0116)
DESCRIPTION Refer to DTC P0115 (See page ). DTC No. DTC Detection Condition Trouble Area P0116 When either of the following conditions is met (2 trip detection logic). During engine ...

Power Management Control ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Power Management Control ECU Communication Stop Mode "Electric Power Control" is not displayed on the CAN Bus Check screen ...