DESCRIPTION
This DTC is stored when there is an open or short in the transponder key coil (built into the engine switch).
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B2784 |
Transponder key coil is open or shorted. |
|
CAUTION / NOTICE / HINT
NOTICE:
If the certification ECU (smart key ECU assembly) is replaced, register the key (See page ).
PROCEDURE
1. |
CHECK DTC OUTPUT |
(a) Clear the DTCs (See page ).
(b) Recheck for DTCs (See page ).
OK:
DTC B2784 is not output.
OK |
USE SIMULATION METHOD TO CHECK |
|
2. |
REPLACE ENGINE SWITCH |
(a) Replace the engine switch (See page for
2GR-FE, See page for 1AR-FE)).
|
3. |
CHECK DTC OUTPUT |
(a) Clear the DTCs (See page ).
(b) Recheck for DTCs (See page ).
OK:
DTC B2784 is not output.
OK |
END (ENGINE SWITCH WAS DEFECTIVE) |
NG |
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Transmission Fluid Pressure Sensor / Switch "E" Circuit Low (P0989,P0990)
DESCRIPTION
ATF pressure switch No. 3 is installed in the lock-up solenoid ATF output passage
and is used to detect a malfunction in the lock-up solenoid.
DTC No.
DTC Detection Condition
Trouble Area
P0989
...
Washer Motor(for Front Side)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL RH
2. REMOVE FRONT FENDER OUTSIDE MOULDING RH
HINT:
Use the same procedure for the RH side and LH side (See page
).
3. REMOVE FRONT FENDER LINER RH
...
Brake Override System
DESCRIPTION
When the vehicle is being driven, depressing the accelerator pedal sensor assembly
and brake pedal will activate the brake override system to restrict driving torque.
The conditions for activating the brake override system as well as the items ...