Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT AMBIENT TEMPERATURE SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
1 - 2 |
10°C (50°F) |
3.00 to 3.73 kΩ |
1 - 2 |
15°C (59°F) |
2.45 to 2.88 kΩ |
1 - 2 |
20°C (68°F) |
1.95 to 2.30 kΩ |
1 - 2 |
25°C (77°F) |
1.60 to 1.80 kΩ |
1 - 2 |
30°C (86°F) |
1.28 to 1.47 kΩ |
1 - 2 |
35°C (95°F) |
1.00 to 1.22 kΩ |
1 - 2 |
40°C (104°F) |
0.80 to 1.00 kΩ |
1 - 2 |
45°C (113°F) |
0.65 to 0.85 kΩ |
1 - 2 |
50°C (122°F) |
0.50 to 0.70 kΩ |
1 - 2 |
55°C (131°F) |
0.44 to 0.60 kΩ |
1 - 2 |
60°C (140°F) |
0.36 to 0.50 kΩ |
NOTICE:
HINT:
As the temperature increases, the resistance decreases (see the graph).
If the resistance is not as specified, replace the ambient temperature sensor.
Text in Illustration
*1 |
Component without harness connected (Ambient Temperature Sensor) |
*2 |
Sensing Portion |
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE COOL AIR INTAKE DUCT SEAL
3. REMOVE RADIATOR GRILLE
4. REMOVE AMBIENT TEMPERATURE SENSOR
(a) Disconnect the connector. |
|
(b) Disengage the clamp to remove the ambient temperature sensor.
Installation
INSTALLATION
PROCEDURE
1. INSTALL AMBIENT TEMPERATURE SENSOR
(a) Engage the clamp to install the ambient temperature sensor. |
|
(b) Connect the connector.
2. INSTALL RADIATOR GRILLE
3. INSTALL COOL AIR INTAKE DUCT SEAL
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
LVL Terminal Circuit
DESCRIPTION
By connecting terminals LVL and CG of the DLC3, the headlight leveling
ECU assembly initializes the height control sensor signal.
WIRING DIAGRAM
PROCEDURE
1.
CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGH ...
Removal
REMOVAL
PROCEDURE
1. REMOVE BACK DOOR PANEL TRIM ASSEMBLY
2. REMOVE REAR WIPER ARM HEAD CAP
(a) Disengage the 4 claws and remove the rear wiper arm head cap as shown
in the illustration.
3. ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
After replacing the stereo component tuner assembly of vehicles subscribed to
pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS
System).
HINT:
Use the table below to help determi ...