Toyota Venza: Air Conditioning System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Actuator Check
- Lost Communication with ECM (U0100-U0142,U0155)
- Front Passenger Side Solar Sensor Short Circuit (B14A3)
- Driver Side Solar Sensor Short Circuit (B14A2)
- Compressor Solenoid Circuit (B1451/51)
- BUS IC Communication Malfunction (B1497/97)
- Air Mix Damper Control Servo Motor Circuit (Driver Side) (B1446/46)
- Air Inlet Damper Control Servo Motor Circuit (B1442/42)
- Air Outlet Damper Control Servo Motor Circuit (B1443/43)
- Air Mix Damper Control Servo Motor Circuit (Passenger Side) (B1441/41)
- Pressure Sensor Circuit (B1423/23)
- Evaporator Temperature Sensor Circuit (B1413/13)
- Compressor Lock Sensor Circuit (B1422/22)
- Room Temperature Sensor Circuit (B1411/11)
- Ambient Temperature Sensor Circuit (B1412/12)
- Air Conditioning Control Panel Circuit
- Air Conditioning Compressor Magnetic Clutch Circuit
- Blower Motor Circuit
- IG Power Source Circuit
- Back-up Power Source Circuit
Air Conditioning Pressure Sensor
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL AIR CONDITIONING PRESSURE SENSOR
(a) Sufficiently apply compressor oil to a new air conditioni ...
Precaution
PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System Name
See Proc ...
Other materials about Toyota Venza:
Cleaning and protecting the vehicle exterior
Perform the following to protect the vehicle and maintain it in prime condition.
• Working from top to bottom, liberally apply water to the vehicle body, wheel
wells and underside of the vehicle to remove any dirt and dust.
Wash the vehicle body using a ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT TIE ROD ASSEMBLY LH
(a) Secure the tie rod assembly LH in a vise.
(b) Install the nut to the stud bolt.
(c) Flip the ball joint back and forth 5 times.
(d) Set a to ...
Diagnosis System
DIAGNOSIS SYSTEM
1. CHECK DLC3
(a) Check the DLC3 (See page ).
2. FUNCTION OF P/S WARNING LIGHT
(a) When a malfunction is detected in the power steering system, the P/S warning
light on the accessory meter comes on to inform the driver of the malfunctio ...
0.1755