Toyota Venza: Air Conditioning Amplifier

Toyota Venza Service Manual / Heating / Air Conditioning / Air Conditioning Amplifier

Components

COMPONENTS

ILLUSTRATION

Installation

INSTALLATION

PROCEDURE

1. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY

(a) Install the air conditioning amplifier assembly with the 2 screws.

(b) Connect each connector.

NOTICE:

Be careful when installing the air conditioning amplifier assembly. If the air conditioning amplifier assembly is dropped, replace it with a new one.

2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure for the RH side and the LH side (See page ).

5. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure for the RH side and the LH side (See page ).

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

Removal

REMOVAL

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure for the RH side and the LH side (See page ).

3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure for the RH side and the LH side (See page ).

4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

5. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

6. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY

(a) Disconnect each connector.

(b) Remove the 2 screws and air conditioning amplifier assembly.

NOTICE:

Be careful when removing the air conditioning amplifier assembly. If the air conditioning amplifier assembly is dropped, replace it with a new one.

Air Conditioning Panel

Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (a) Connect the connector. (b) Engage the 2 clips and 4 gui ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL LH 2. REMOVE FRONT FENDER OUTSIDE MOULDING LH 3. REMOVE FRONT FENDER LINER LH (a) Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips. Text in Illustration ...

Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL) (P2769,P2770)
DESCRIPTION Shift solenoid valve SL is turned on and off by signals from the TCM to control the hydraulic pressure acting on the lock-up relay valve, which then controls operation of the lock-up clutch. DTC No. DTC Detection Conditi ...

Automatic door locking and unlocking systems
The following functions can be set or canceled: - Setting and canceling the functions ► Setting and canceling the functions Vehicles with TFT type multi-information display The function settings can be changed using the multi-information dis ...