ADJUSTMENT
PROCEDURE
1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Remove the transmission control shaft lever.
HINT:
See the steps from "Remove Cool Air Intake Duct Seal" through "Remove Park/Neutral Position Switch Assembly" (See page ).
(b) Loosen the 2 bolts of the park/neutral position switch. |
|
(c) Align the protrusions of the park/neutral position switch. Text in Illustration
|
|
(d) Hold the park/neutral position switch in position and tighten the 2 bolts. Torque: 5.4 N·m {55 kgf·cm, 48 in·lbf} NOTICE: After installing the park/neutral position switch, confirm that the 2 protrusions on the switch are aligned. |
|
(e) Install the transmission control shaft lever.
HINT:
See the steps from "Install Park/Neutral Position Switch Assembly" through "Install Cool Air Intake Duct Seal" (See page ).
(f) After the adjustment, perform the switch operation check (See page ).
On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation procedures of the front
seat side airbag assembly.
PROCEDURE
1. INSPECT FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
(a ...
Skid Control ECU Malfunction (C1300/62)
DESCRIPTION
The skid control ECU outputs this DTC, if malfunctions are found in the circuit
inside the ECU by self diagnosis.
DTC Code
DTC Detection Condition
Trouble Area
C1300/62
Internal failu ...
Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power
Window Switch LH
DESCRIPTION
If the manual up/down function can be performed but the auto up/down function
cannot, the fail-safe mode may be functioning.
If the power window initialization (See page
) has not been performed, the auto up/down function
will not operate.
...