ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE COOL AIR INTAKE DUCT SEAL
2. REMOVE RADIATOR GRILLE
3. ADJUST HOOD SUB-ASSEMBLY
(a) Horizontally and vertically adjust the hood.
(1) Loosen the 4 hinge bolts of the hood. |
|
(2) Adjust the clearance between the hood and front fender by moving the hood.
(3) Tighten the 4 hinge bolts after the adjustment.
Torque:
13 N·m {133 kgf·cm, 10 ft·lbf}
(b) Adjust the height of the front end of the hood using the cushion rubbers.
(1) Adjust the 2 cushion rubbers so that the heights of the hood and fender are aligned. HINT: Raise or lower the front end of the hood by turning the 2 cushion rubbers. |
|
(c) Adjust the hood lock.
(1) Using a screwdriver, remove the hood lock nut cap. Text in Illustration
HINT: Tape the screwdriver tip before use. |
|
(2) Loosen the 3 bolts. |
|
(3) Tighten the bolts after the adjustment.
Torque:
<A> :
7.5 N·m {77 kgf·cm, 66 in·lbf}
Torque:
<B> :
8.0 N·m {82 kgf·cm, 71 in·lbf}
(4) Check that the striker can engage with the hood lock smoothly.
(d) Install a new hood lock nut cap. |
|
4. INSTALL RADIATOR GRILLE
5. INSTALL COOL AIR INTAKE DUCT SEAL
Transmitter ID not Registered (C2171/71)
DESCRIPTION
Each tire pressure warning valve and transmitter ID is registered to the tire
pressure warning ECU.
When the ECU detects a transmitter ID code not registered in the ECU, a DTC is
output.
DTC No.
DTC Detection Condition
...
Terminals Of Ecu
TERMINALS OF ECU
1. A/C AMPLIFIER
HINT:
Check from the rear of the connector while it is connected to the A/C amplifier.
Terminal No.
(Symbol)
Wiring Color
Terminal Description
Condition
Specified ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the audio and visual system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...