Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL ACCESSORY METER ASSEMBLY (w/o Rear View Monitor System)
(a) Connect the connector. |
|
(b) Engage the 2 clamps.
(c) Engage the 2 clips. |
|
(d) Install the accessory meter assembly with the 2 bolts.
2. INSTALL ACCESSORY METER ASSEMBLY (w/ Rear View Monitor System)
(a) Connect the connectors. |
|
(b) Engage the 2 clamps.
(c) Engage the 2 clips. |
|
(d) Install the accessory meter assembly with the 2 bolts.
3. INSTALL DEFROSTER NOZZLE GARNISH
Removal
REMOVAL
PROCEDURE
1. REMOVE DEFROSTER NOZZLE GARNISH
2. REMOVE ACCESSORY METER ASSEMBLY (w/o Rear View Monitor System)
(a) Remove the 2 bolts. |
|
(b) Disengage the 2 clips.
(c) Disengage the 2 clamps. |
|
(d) Disconnect the connector and remove the accessory meter assembly.
3. REMOVE ACCESSORY METER ASSEMBLY (w/ Rear View Monitor System)
(a) Remove the 2 bolts. |
|
(b) Disengage the 2 clips.
(c) Disengage the 2 clamps. |
|
(d) Disconnect the connectors and remove the accessory meter assembly.
Engine oil
With the engine at operating temperature and turned off, check the oil level
on the dipstick.
- Checking the engine oil
Park the vehicle on level ground.
After warming up the engine and turning it off, wait more than five minutes for
the oil to ...
Driver Side Door Entry Lock Function does not Operate
DESCRIPTION
If the driver door entry unlock function operates normally, but its entry lock
function does not, this means that the request code from the driver door is being
output normally. In this case, a malfunction in the lock sensor circuit (from the ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (See page
).
2. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG
HAS NOT D ...