Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE RH
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
4. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
5. REMOVE 4WD CONTROL ECU
(a) Disconnect the connector. |
|
(b) Remove the 2 nuts and ECU. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL 4WD CONTROL ECU
(a) Install the ECU with the 2 nuts. Torque: 8.5 N·m {87 kgf·cm, 75 in·lbf} |
|
(b) Connect the connector. |
|
2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
5. INSTALL FRONT DOOR SCUFF PLATE RH
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT REFRIGERANT PRESSURE WITH MANIFOLD GAUGE SET
HINT:
This is a method where a manifold gauge set is used to help locate the problem.
(a) Read the manifold gauge pressure when the following conditions are met:
Test ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT TIE ROD ASSEMBLY LH
(a) Secure the tie rod assembly LH in a vise.
(b) Install the nut to the stud bolt.
(c) Flip the ball joint back and forth 5 times.
(d) Set a to ...
Hill-start assist control
Hill-start assist control helps to prevent the vehicle from rolling backwards
when starting on incline or slippery slope.
To engage hill-start assist control, further depress the brake pedal when the
vehicle is stopped completely.
A buzzer will sound o ...