Toyota Venza: 1ar-fe Fuel

Installation

INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE OIL SEAL (a) Apply MP grease to the lip of a new oil seal. NOTICE: Do not allow foreign matter to contact the lip of the oil seal. Do not ...

Fuel Injector

...

Other materials about Toyota Venza:

Front Door Courtesy Switch
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT COURTESY LIGHT SWITCH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch C ...

ECU Power Source Circuit
DESCRIPTION This circuit provides power for main body ECU (driver side junction block assembly) operation. WIRING DIAGRAM PROCEDURE 1. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU (POWER SOURCE)) ...

Engine Switch Illumination Circuit
DESCRIPTION The illuminated entry system controls the engine switch illumination. WIRING DIAGRAM PROCEDURE 1. PERFORM ACTIVE TEST USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to O ...