Toyota Venza: 1ar-fe Emission Control

Installation

INSTALLATION PROCEDURE 1. INSTALL WATER PUMP ASSEMBLY (a) Install a new gasket and the water pump with the 7 bolts. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} ...

Canister

...

Other materials about Toyota Venza:

Replacement
REPLACEMENT PROCEDURE 1. REPLACE RING PIN NOTICE: It is not necessary to remove the ring pin unless it is being replaced. (a) Remove the 12 ring pins. (b) Using a plastic-faced hammer, install 12 new ring pins. Standard Protrusion Height: ...

On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the front seat side airbag assembly. PROCEDURE 1. INSPECT FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) (a ...

Turn signal lever
1. Right turn 2. Left turn 3. Move and hold the lever partway to signal a lane change. The right hand signal will flash until you release the lever. 4. Move and hold the lever partway to signal a lane change. The left hand signal will flash until you re ...