Toyota Venza: Using the AUX port/USB port
This port can be used to connect a portable audio device and listen to it through the vehicle’s speakers.
Open the cover.
Connect the portable audio device.
- Operating portable audio devices connected to the audio system
The volume can be adjusted using the vehicle’s audio controls. All other adjustments must be made on the portable audio device itself.
- Cable pass-through
Fuel consumption display (vehicles with Display Audio system)
The actual display may differ from that shown in “Display Audio System Owner’s
Manual”.
• The information related to fuel consumption is also displayed on the multi-information
display. ( ...
Other materials about Toyota Venza:
Propeller Shaft System
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple
suspected areas are listed, the potential causes of the symptoms are listed in order
of probability in the "Suspe ...
Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION
Refer to DTC P0136 (See page ).
HINT:
When any of these DTCs are stored, the ECM enters fail-safe mode. The
ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe
mode continues until the ignition switch is t ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE STEERING RACK BOOT CLIP (for LH Side)
(a) Using pliers, remove the steering rack boot clip.
2. REMOVE STEERING RACK BOOT CLIP (for RH Side)
HINT:
Perform the same procedure as for the LH side.
3. REMOVE NO. 2 STEERING RAC ...
0.1537